Firmware Upgrade; Remote Downloading - Bentel Security KYO 320 Installation Manual

3. Select the parameters to be downloaded, as fol -
lows:
– select Parameters from the Settings menu;
– enter a valid Installer code in the Installer code
field;
–select the Control panel type from the Panel type
menu;
–select the relevant firmware release from the
Firmware Release menu;
– click OK.
4. To download a specific page: click the Download
button on the page concerned.
5. To Download several pages:
– select the required page from the Folders menu,
right click, select Tag (a ü on the page Icon indi -
cates that it will be downloaded);
– repeat the procedure for all the required Pages;
– right click again then select Download.
+
To download a family of pages, select the root.
!
If you send the User page with other pages, the
Control panel WILL STORE the Description, En-
abled Partitions, Associated Timers, User Menu
Access and Code type parameters, but WILL NOT
STORE the Available status, Active status, Duress
Code, Patrol Code and Father Code parameters.
+
If changes to the Descriptions are not shown on the
Keypads, use the Broadcast Keyp.command
from the INSTALLER MENU.
For example: – to download all the Configuration re -
lated pages, select Configuration from the Folders
menu; to download All the Pages, select KYO 320 from
the Folders menu.
6. To view the parameters of the connected Control
Panel, work carefully through point 4. then select
Upload instead of Download.
Figure 53 Connecting Window
KYO320

Firmware Upgrade

Under "Programming Menu" in addition to Upload and
Download item there is Firmware Upgrade.
When a new Firmware is released, a file .hex will be
given to the installer. This file will run after selecting the
"Start" button (see Figure 53). In this fase if the system
goes in black-out or block, it is necessary to check on
"Restore Panel" and click on "Start". To restore the sys-
tem with the default setting call the Service).

Remote Downloading

You can download the programming data via telephone
line, using a B-Mod or B-Mod/RX modem, as follows.
+
Telephone access requires entry of the Installer code
PIN, and will ONLY be allowed when the Teleservice
option has been Enabled by the User (refer "En-
able/Disable Teleservice" in the USER'S MANUAL).
1. Using the serial cable (the same as used for On-site Down-
loading), connect the Modem to one of the PC serial ports.
2. Select the PC serial port for connection with the
Modem, as follows:
– select Serial Ports from the Settings menu;
– select the serial port (Modem section);
– select OK.
3. Select Connecting from the Modem menu: this com-
mand will open the Connecting window ( Figure 53).
4. Program the following parameters:
– Telephone Number – enter the Control panel
telephone number;
– Disable Tone Check – Enable/Disable this op-
tion as required.
If this option is Enabled, the Modem will not check
for the dialling tone before dialling;
– Double call – refer to the Teleservice page;
– Call back – refer to the Teleservice page;
– Installer Code – enter a valid Installer code PIN
(enabled for Downloading)
When the Connecting window opens, the above pa-
rameters (except for Disable Tone Check) will have
the programmed settings.
Figure 54 Upgrade Firmware window
PROGRAMMING 85