ZOLL R Series Service Manual page 99

Removing Digital Board
1. Remove 9 screws holding digital board to assembly.
Note: During reassembly, inspect standoffs and corner post to verify they
are not stripped. Replace them if necessary. Torque 4 corner screws
(longer) to 6 in-lbs and the 5 inter screws to 4 in-lbs.
9650-0903-01 Rev. L
2. Tilt assembly up, and carefully pull board
toward you to disconnect from connectors.
Note: Since ferrite beads on connector are loose, make sure they
are in place during reassembly.
7
R Series Service Manual
3-31