ZOLL R Series Service Manual page 57

Error Message
CF TRANSFER FAILED
CHANGE LEADS
CHARGE FAILED
CHECK CO2 ADAPTER
CHECK CO2 SENSOR
CHECK CUFF/HOSE
CHECK ECG CABLE
CHECK ELECTRODE
CHECK PADS
CHECK PATIENT
CHECK PULSE
9650-0903-01 Rev. L
Explanation
Summary/DVCK/ALOG data file transfer error – either no
CF card or CF card transfer failed
Unit is in Defib Sync mode and heart rate is less than 20
BPM.
Unit failed to perform the requested charge.
Airway adapter is removed, occluded or adapter zeroing
needs to be performed or was performed incorrectly.
EtCO Sensor is unplugged or defective.
2
• Blood pressure cuff or hose is not installed correctly.
• Cuff or hose is faulty.
• Hose is kinked or disconnected.
• Inflation rate too fast or too slow.
Invalid ECG cable Id is detected.
Either Can read ID Chip or the checksum failed.
Message displayed in conjunction with either POOR PAD
CONTACT or DEFIB PAD SHORT.
Background ECG analysis detects shockable rhythm.
Alternate message for NO SHOCK ADV. message, or
displayed in addition to it according to the configuration
option selected. Also shown after delivering last shock
when Auto Analyze option is enabled.
User Technical Action
Advisory
Reseat CF Communication cable or replace
Communication Module.

Replace PD Engineer or Analog Board.

Replace/Clean airway adapter. Zeroing performed
automatically.

Check that sensor cable is plugged in and seated
properly. Check that sensor is not exposed to
excessive heat. If problem persists, replace the
sensor.
• Verify the hose and cuff is properly connected
and not leaking.
• Replace cuff and hose.
Replace NIBP module or parameter power
•
supply.
• Verify that the ECG Cable is property
connected.
• Replace ECG Cable.
• Replace Analog Board.
Replace Electrodes or replace Analog board.

Ensure pads are coupled to patient. Check/
replace pads and universal cable. Replace system
board.


R Series Service Manual
2-3