ZOLL R Series Service Manual page 100

R Series Service Manual
Removing Pace Defibrillator Engine
1. PD Engine: Remove 9 screws holding PD Engine to
assembly.
Note: During reassembly, inspect standoffs and corner post to verify they
are not stripped, replace them if necessary. Torque 4 corner screws
(longer) to 6 in-lbs, and the 5 inter screws to 4 in-lbs.
7
3-32
2. Carefully remove cable from PD Board.
Note: Use a rocking motion to unseat connector from board.
9650-0903-01 Rev. L