Using Code Markers - ZOLL R Series Service Manual

C 2 P
HAPTER RODUCT
Press the High Bright or Low Bright softkey to select high and low brightness.
2.
Note:

Using Code Markers

Pressing the CODE MARKER softkey causes the unit to display a preconfigured list of
clinical actions. Pressing the softkey associated with a particular action causes that action, and
6 seconds of ECG, to be recorded along with a date and time stamp in the Summary Report
memory. You can supplement an event summary by manually adding code markers which
itemize drugs or treatments administered to the patient.
Up to six Code Markers can be displayed on the screen at one time.
Figure 2-14. Code Markers
The right-most softkey is labeled MORE when there are more than six items on the code
marker list. Press the MORE softkey to see the next set of Code Markers displayed above the
softkeys.
Separate code marker lists are maintained for DEFIB, MONITOR, and PACER modes, thereby
enabling the display of appropriate code markers for each particular protocol. (For information
on configuring these code marker lists, refer to the R Series Configuration Guide.)
The code markers are removed from the display after 10 seconds. If no Code Marker softkey
has been pressed during that time, a "default" event mark is stored in Summary Report
memory.
2–14
O
VERVIEW
Brightness level affects battery run time. Selecting high bright will cause the battery
charge to be depleted at a faster rate than when selecting low bright.
CPR Intubate
www.zoll.com
EPI LIDO Narcan MORE
9650-0912-01 Rev. N