Table of Contents
Advertisement
NETWORK SETUP (NET) (CONTINUED)
ETH0
GATE
HOST
MAC0
SUB0
EXAMPLES:
(NET+ETH0 "192.168.1.35") Set new IP address on the MGMT Ethernet controller
(NET+GATE "192.168.0.1") Set the gateway
(NET+SUB0 "255.255.255.0") Set the subnet mask on the MGMT Ethernet controller
(NET+HOST "MyHostName") Set the host name
(NET+ETH0 ?) Retrieve IP address from the MGMT Ethernet controller. (NET+ETH0! 192.168.1.35)
(NET+MAC0 ?) Retrieve MAC address from MGMT controller. (NET+MAC0! 00:12:3F:7B:76:B4)
(NET+GATE ?) Retrieve default gateway. (NET+GATE! 192.168.0.1)
(NET+DLP0 "192.168.206.10") Set IP address (deprecated)
(NET+DLP0?) (NET+DLP0! "192.168.206.10") Query IP address (deprecated)
PROJECTOR CONFIGURATION FILE (PCF)
Set Projector Configuration File (PCF) file for the specified channel. This file is used to configure many aspects of
the electronics. It will only be used if PCF in use (PIU) control is set.
SUBCODE
Cxxx
NONE
EXAMPLES:
(PCF+C108 "SCOPE 2.39") Use PCF file "Scope 2.39" on channel 108. File used when PIU is on
(PCF?L) List all entries of PCF control
PCF IN USE (PIU)
Select whether to use the PCF file or not.
SUBCODE
Cxxx
NONE
EXAMPLES:
(PIU?) Get the current status of PCF file
(PIU+C108 1) Use PCF file on channel 108
(PIU+C108 0) Do not use PCF file on channel 108
D4K25 Service Manual
020-100880-01 Rev. 1 (06-2012)
Set the WAN IP address for the projector
Set the WAN Gateway for the projector
Host name
Gets the MAC address of the projector
Set the WAN subnet mask for the projector
DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101 - 164.
Select PCF file for the current channel
DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101 - 164.
Select "Use PCF" for the current channel
Section 7: Serial API
7-17
Advertisement
Table of Contents
