Connector-A Board; Procedure; Interlock Switch; Lamp 1 Driver Board - Christie E Series Service Manual

8. Pinch stand-offs (4) to release Lamp 1 Driver Board from bracket. See Figure 5-33.
9. Replace Lamp 1 Driver Board.
5.2.21Lamp 2 Driver Board
Replacement Time: 25 minutes

Procedure:

1. Remove Top Cover. See
2. Remove Top Shield. See
3. Disconnect all harness from Connector-A Board. See
4. Disconnect Interlock harness. See
5. Remove screws (5). See Figure 5-34.
6. Pull up Power Supply Cover assembly to expose harness underneath.
E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)
F 5-33 R L
IGURE EMOVE
5.2.5 Top Cover.
5.2.7 Top Shield.
5.2.19 Interlock
F 5-34 R P
IGURE EMOVE
Section 5: Parts and Module Replacement
1 D B
AMP RIVER OARD
5.2.18 Connector-A
Switch.
S C
OWER UPPLY OVER
Board.
5-21