Christie D4K25 Service Manual page 120

Section 7: Serial API
SUBCODE
ICPC
EXAMPLE:
(TIG+ICPC?) Gets the ICP certificate
3D INPUT REFERENCE (TIR)
Setup the Input Reference for 3D control.
SUBCODE
Cxxx
NONE
EXAMPLES:
(TDK+C101 "Use GPI (polarity=true)") set Input Reference to 'Use GPI (polarity=true)' on channel 101
(TDK+C101?) get Input Reference for channel 101
TIME/DATE (TMD)
Set/get the time, date and time zone.
SUBCODE
DATE
DSTA
TIME
TOFF
ZONE
EXAMPLES:
(TMD+DSTA?) 0 or 1 (DST OFF or DST ON)
(TMD+DSTA 0) Turn daylight savings OFF (0) or ON (1)
(TMD+ZONE 20) Set time zone to EST
(TMD+TIME? ) Get local time (TMD+TIME! 17:50:45)
(TMD+TOFF 120) Increase the time by two minutes.
("TMD+TOFF: Disabled Control") Error message returned when power is OFF.
3D OUTPUT REFERENCE POLARITY (TOP)
Setup output timing signal reference polarity for 3D control.
SUBCODE
7-26
DESCRIPTION OF USE
Retrieve ICP Certificate
DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101-164.
Select input reference for the current channel.
DESCRIPTION OF USE
Get the date in the form yyyy/mm/dd. Read-only.
Set/get the daylight savings time adjust value.
Set/get the local time in the form hh:mm:ss. Ready only.
Set Time Offset in seconds (± 900 seconds). Must be powered ON. (Write-only)
Set/get the time zone
DESCRIPTION OF USE
D4K25 Service Manual
020-100880-01 Rev. 1 (06-2012)