Table of Contents
Advertisement
LAMP HOURS (LPH)
Get information on installed lamp. Read only control.
SUBCODE
FLSK
FRSK
LPOF
NONE
TLSK
EXAMPLES:
(LPH?) Get usage in hours
(LPH+FLSK?) Get lamp strikes
LAMP INTENSITY (LPI)
Set lamp intensity setpoint. The value is used when lamp mode is set to LiteLOC™. The projector will adjust the
Lamp Power to maintain this intensity. NOTE: This command can only be used to update the current lamp file.
Changing the lamp intensity for the current channel will change the lamp intensity for any channel using the same
lamp file.
SUBCODE
Cxxx
NONE
EXAMPLES:
(LPI 4500) Set lamp intensity to 4500 for current channel
(LPI+C103 4000) Set the lamp intensity to 4000 for channel 3
(LPI?) Get lamp intensity for the active channel
LAMP LIFE (LPL)
Set/get expected lamp life in hours. The default hours will be used if lamp life is 'not set'. Lamp expiry message
will be sent out when lamp usage is over the lamp life.
SUBCODE
LIFE
NONE
D4K25 Service Manual
020-100880-01 Rev. 1 (06-2012)
DESCRIPTION OF USE
Return total failed lamp strikes on the installed lamp
Return total failed lamp restrikes on the installed lamp
Return total lamp unexpected off times on the installed lamp
Return lamp usage for current lamp in hours.
Return total lamp strikes on the installed lamp
DESCRIPTION OF USE
Replace Cxxx with the channel number. Valid range is 101-164.
Set lamp intensity for the current channel.
DESCRIPTION OF USE
0 - No warning will be generated.
1 - Lamp Life Expiry Warning will be generated when lamp hours extends past lamp life. Warn-
ing will be reported in SST. Warning will be cleared by extending lamp life or changing the
lamp.
Set or get expected lamp life.
Section 7: Serial API
7-13
Advertisement
Table of Contents
