Table of Contents
Advertisement
3D OUTPUT REFERENCE POLARITY (TOP) (Continued)
Cxxx
NONE
EXAMPLES:
(TOP+C101 1) Set Output Reference Polarity to 1 on channel 101
(TOP+C101?) Get Output Reference Polarity on channel 101
USER ID (UID)
Allows users to login to the serial interface.
SUBCODE
NONE
EXAMPLES:
(UID) "username" "password") Login a user
(UID) Logout the current user, also happens automatically when a new user logs in
(UID?)(UID! "username" 01) Display the current logged in user and their access level
ZOOM LENS POSITION ADJUSTMENT (ZOM)
Adjust lens to specific zoom position with a specified direction (1, -1). NOTE: This command can only be used to
update the current ILS file. Changing the zoom for the current channel will change the zoom for any channel using
the same ILS file.
Use command without subcode:
• If ILS is ON, motor will move to specified steps and save data to the active channel.
• If ILS is OFF, motor will move to specified steps, do not save data to the active channel.
SUBCODE
BACN
BACP
CALB
Cxxx
NONE
RNGN
RNGP
RSET
STRT
D4K25 Service Manual
020-100880-01 Rev. 1 (06-2012)
Replace xxx with the channel number. Valid range is 101-164.
Select output reference polarity for the current channel.
DESCRIPTION OF USE
None
DESCRIPTION OF USE
Motor backlash in negative direction. Read-only.
Motor backlash in positive direction
Calibrate travel range and backlash on specified. Only valid parameter for this command is 1. Set only
command.
Replace xxx with the channel number. Valid range is 101-164.
Moving lens mount to a specified vertical position.
Motor moving range in negative direction
Motor moving range in positive direction
Move motor to the center flag then move back to current position. Only valid parameter for this command
is 1. Set only command.
Start motor moving in specified direction, where direction can be (-1, 1). Write-only for v1.3 or newer.
. Read-only.
. Read-only.
. Read-only.
Section 7: Serial API
7-27
Advertisement
Table of Contents
