Table of Contents
Advertisement
User's Manual of OWON Color Mixed Signal Digital Storage Oscilloscope
Appendix A: Technical Specifications
Unless otherwise specified, the technical specifications applied are applicable to the
probe with the attenuation switch setting 10X and the MSO series digital oscilloscope.
Only if the oscilloscope fulfill the following two conditions at first, can these
specification standards be reached.
This instrument should run for more than 30 minutes continuously under the
specified operating temperature.
If the change range of the operating temperature is up to or exceeds 5℃, open the
system function menu and execute the "Auto-calibration" procedure.
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Digital Storage Oscilloscope
Sampling
ACQU Mode
Sampling Rate
Input
Input Coupling
Input Impedance
Probe attenuation coefficient
Max. Input Voltage
Level
Sampling Rate Range
Waveform interpolation
Record Length
Scanning Speed Range
(S/div )
Accuracy of Sampling Rate
and Delay Time
Measuring Accuracy of Time
Interval ( T)
△
(Full
Bandwidth)
Sample
Peak Detection
Average
100 MS/s
DC, AC
1MΩ± 2%, connected with 20pF± 5pF in parallel
1X, 10X, 100X, 1000X
300V, Peak Value
10S/s ～ 100MS/s
(sinx) /x
5000 sampling points per channel
5ns/div～5s/div, according to the stepping mode of
1- 2.5- 5.
± 100ppm ( for any time interval equal to or greater
than 1ms)
Single: ± (One Sampling Interval Time +100ppm ×
Reading +0.6ns)
>Averages of 16: ± (One Sampling Interval Time
+100ppm× Reading +0.4ns)
102
Advertisement
Table of Contents
