Demonstration; Example 1: Measurement Of Simple Signals - Owon MSO5022 User Manual

User's Manual of OWON Color Mixed Signal Digital Storage Oscilloscope

Demonstration

Example 1: Measurement of Simple Signals

Observe an unknown signal in the circuit, and display and measure rapidly the
frequency and peak-to-peak value of the signal.
1. Carry out the following operation steps for the rapid display of this signal:
1. Set the probe menu attenuation coefficient as 10X and that of the switch in the
probe switch as 10X.
2. Connect the probe of Channel 1 to the measured point of the circuit.
3. Push down the AUTOSET button.
The oscilloscope will implement the AUTPSET to make the wave form optimized,
based on which, you can further regulate the vertical and horizontal divisions till the
waveform meets your requirement.
2. Perform Automatic Measurement
The oscilloscope can measure most displayed signals automatically. Complete the
following operations for the measurement of frequency, cycle, mean and peak-to-peak
value:
1. Press the MEASURE button to show the automatic measurement function menu.
2. Press the F1 menu selection button and choose Source, with the Source menu
displayed.
3. Press the F2, F3, F4 and F5 menu selection buttons and choose CH1.
4. Press the F1 menu selection button again and choose Type, with the Type menu
displayed.
5. Press the F2 menu selection button and choose Freq.
6. Press the F3 menu selection button and choose Period.
7. Press the F4 menu selection button and choose Mean.
8. Press the F5 menu selection button and choose Pk-Pk.
Then, the frequency, cycle, mean and peak-to-peak value will present in the menu and
change periodically (see Fig. 90).
91