Owon MSO5022 User Manual page 33

User's Manual of OWON Color Mixed Signal Digital Storage Oscilloscope
2. Setting the Channel "ON/OFF"
Taking the Channel 1 for example, the operation steps are shown as below:
(1). Press the CH1 MENU button and call out the CH1 SETUP menu.
(2). Press the F2 menu selection button and select the Channel as OFF, with
Channel 1 switched off.
(3). Press F2 menu selection button again, select the channel as ON, with
Channel 1 is switched on.
3. Regulate the Attenuation Ratio of the Probe
In order to match the attenuation coefficient of the probe, it is required to adjust
the attenuation ration coefficient of the probe through the operating menu of the
Channel accordingly. If the attenuation coefficient of the probe is 1:1, that of the
oscilloscope input channel should also be set to 1X to avoid any errors presented
in the displayed scale factor information and the measured data.
Take the Channel 1 as an example, the attenuation coefficient of the probe is 1:1,
the operation steps is shown as follows:
(1). Press the CH1 MENU button, access CH1 SETUP menu.
(2). Press the F3 menu selection button and select 1X for the probe.
The Figure 23 illustrates the setting and the vertical scale factor when the probe
of the attenuation coefficient of 1:1.is used.
Fig. 23 Regulation of the Attenuation Ratio of the Probe
33