Table of Contents
Advertisement
User's Manual of OWON Color Mixed Signal Digital Storage Oscilloscope
corresponding to the status bar has been changed accordingly.
Press buttons of "CH1 MENU", "CH2 MENU" and "MATH MENU", the
operation menu, symbols, wave forms and scale factor status information of the
corresponding channel will be displayed in the screen.
Introduction to the Horizontal System
Shown as Fig.10, there are a button and two knobs in the "HORIZONTAL
CONTROLS". The following practices will gradually direct you to be familiar with
the setting of horizontal time base.
1. Use the horizontal "SEC/DIV" knob to change the horizontal time base setting
and observe the consequent status information change. Rotate the horizontal
"SEC/DIV" knob to change the horizontal time base, and it can be found that the
"Horizontal Time Base" display in the status bar changes accordingly. The
horizontal scanning speed steps from 5ns up to 5s in the sequence of 1=2=5.
2. Use the "HORIZONTAL POSITION" knob to adjust the horizontal position of
the signal in the waveform window. The "HORIZONTAL POSITION" knob is
used to control the triggering displacement of the signal or for other special
applications. If it is applied to triggering the displacement, it can be observed that
the wave form moves horizontally with the knob when you rotate the
"Horizontal Position" knob.
3. With the "HORIZONTAL MENU" button pushed down, you can set and
initiate the Window Expansion.
Fig. 10 Horizontal Control Zone
21
Advertisement
Table of Contents
