Multi-Merchant Configuration - Ingenico 5100 Operating Manual

SKYZER TECHNOLOGIES

3.4 MULTI-MERCHANT CONFIGURATION

This function is used to configure the terminal for Multi-merchant operation. The
terminal can support up to 8 Merchants.
NOTE: After activating the Multi-Merchant configuration, please return to
EFTPOS configuration for Multi-Merchant Function 3824 to enter the Terminal
and Merchant ID's for the active merchants.
Step Terminal Display Description
1.0
FUNCTION? FUNCTION?
2.0 FUNCTION? FUNCTION?
MULTI MERCHANT MULTI MERCHANT
3.0 MULTI MERCHANT MULTI MERCHANT
SETUP SETUP
SETUP SETUP
4.0
ACTIVE MERCHANTS ACTIVE MERCHANTS
ACTIVE MERCHANTS ACTIVE MERCHANTS
12345678 12345678 12345678 12345678
MULTI MERCHANT MULTI MERCHANT MULTI MERCHANT MULTI MERCHANT
5.0
SETUP SETUP SETUP SETUP
6.0
MERCHANT 1 NAME MERCHANT 1 NAME
MERCHANT 1 NAME MERCHANT 1 NAME
MERCHANT 1 MERCHANT 1
MERCHANT 1 MERCHANT 1
7.0 MULTI MERCHANT MULTI MERCHANT MULTI MERCHANT MULTI MERCHANT
SETUP SETUP SETUP SETUP
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE
Press FUNC
Enter 7418, press ENTER
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
Press 3 to Set Active Merchants
Enter the number (from 1 – 8) for each individual merchant you wish to activate
and press ENTER
Example: To activate merchants 1 to 5, enter 12345
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
Press 4 to Set Merchant Name
To change the merchant name, use the numeric keypad then the FUNC key to
access the alpha characters. Press ENTER to advance to the next merchant name
Terminal is now in configuration mode. Go to following steps to proceed or press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
PAGE 33 OF 97
Version 1.3