Dial-Up Configuration Flowchart - Ingenico 5100 Operating Manual

SKYZER TECHNOLOGIES

3.1.2 Dial-Up Configuration Flowchart

START
From the idle screen
press FUNC and
then key in 3824
followed by the
ENTER
Dial-up Configuration
At QUICK DIAL prompt
by default is selected
as 1-YES and press
ENTER to proceed.
If QUICK DIAL prompt
is not required, press
2-NO and then press
ENTER.
At Dial Mode, press
the corresponding
number key to select
preferred dial mode
and press ENTER
1-Tone
2-Pulse
3-Tone/Blind
By default, 1-Tone is
always selected.
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE
Press ENTER at the
CONFIG PARAMS?
At the COMMS MODE,
press the corresponding
number key to select
preferred comms mode
and press ENTER
1-Dial-up
2-TCP-IP/Dial
3-TCP-IP
Enter the PABX
number if required
and press ENTER. To
put in a pause for a
second, put in the
character 'A' by
pressing 2 and then
FUNC or for wait, put
in character 'W' by
pressing 9 and then
FUNC.
PAGE 22 OF 97
Key in the Terminal and
Merchant ID into the
terminal followed by
ENTER.
Network Interface
Identifier (NII) by
default will be selected
as 001 and press ENTER
The HOST PHONE
NO? by default will
be selected as
08797 and press
ENTER.
Save Config Y/N?
Press ENTER to save
or CLEAR to exit
without saving
COMPLETED
Version 1.3