Eftpos Configuration - Ingenico 5100 Operating Manual

SKYZER TECHNOLOGIES

3.2 EFTPOS CONFIGURATION

The EFTPOS Configuration option enables the terminal to be configured to
operate as an EFTPOS terminal and must be done before the terminal can
process transactions.
Step Terminal Display Comment
1.0
2.0 FUNCTION FUNCTION FUNCTION FUNCTION? ? ? ?
CONFIG PARAMS? CONFIG PARAMS?
3.0 CONFIG PARAMS? CONFIG PARAMS?
ENTER OR CLEAR ENTER OR CLEAR
ENTER OR CLEAR ENTER OR CLEAR
4.0 TERMINAL ID? TERMINAL ID? TERMINAL ID? TERMINAL ID?
XXXXXXXX XXXXXXXX XXXXXXXX XXXXXXXX
MERCHANT ID? MERCHANT ID?
5.0 MERCHANT ID? MERCHANT ID?
XXXXXXXXX XXXXXXXXXXX XX
XXXXXXXXX XXXXXXXXX XX XX
NII? NII?
6.0 NII? NII?
001 001
001 001
COMMS MODE? COMMS MODE? COMMS MODE? COMMS MODE?
7.0
1 1 1 1 - - - - DIAL DIAL- - - - UP UP
DIAL DIAL UP UP
COMMS MODE? COMMS MODE?
7.1 COMMS MODE? COMMS MODE?
2 2 2 2 - - - - TCP TCP- - - - I I I I P / Dial TCP TCP P / Dial P / Dial P / Dial
COMMS MODE? COMMS MODE? COMMS MODE? COMMS MODE?
7.2
3 3 3 3 - - - - TCP TCP- - - - IP IP
TCP TCP IP IP
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE
Press FUNC
Enter 3824 and press ENTER.
ENTER to configure the parameters, CLEAR to cancel and exit to idle prompt.
This parameter specifies the Terminal ID that Paymark assigns to the terminal.
Press ENTER.
This parameter specifies the Merchant ID assigned by Paymark.
Press ENTER.
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark.
Press ENTER.
To configure COMMS mode:
Press 1 for Dial-up configuration followed by ENTER and proceed with the
configuration as on page 27.
Press 2 for TCP-IP /Dial backup configuration followed by ENTER and proceed
with the configuration as on page 28 - 29.
Press 3 for TCP-IP configuration followed by ENTER and proceed with the
configuration as on page 30.
PAGE 26 OF 97
Version 1.3