Tcp-Ip Configuration - Ingenico 5100 Operating Manual

SKYZER TECHNOLOGIES

3.2.3 TCP-IP Configuration

PRIMARY PRIMARY PRIMARY PRIMARY
1.0
HOST IP ADDRESS HOST IP ADDRESS
HOST IP ADDRESS HOST IP ADDRESS
117.120.34.110 117.120.34.110
117.120.34.110 117.120.34.110
PRIMARY PRIMARY
2.0 PRIMARY PRIMARY
HOST PORT HOST PORT HOST PORT HOST PORT
33876 33876
33876 33876
SECONDARY SECONDARY
3.0 SECONDARY SECONDARY
HOST IP ADDRESS HOST IP ADDRESS HOST IP ADDRESS HOST IP ADDRESS
117.120.32.110 117.120.32.110
117.120.32.110 117.120.32.110
SECONDARY SECONDARY SECONDARY SECONDARY
4.0
HOST PORT HOST PORT
HOST PORT HOST PORT
33876 33876
33876 33876
5.0
ENABLE DHCP Y/N ENABLE DHCP Y/N
ENABLE DHCP Y/N ENABLE DHCP Y/N
1 1 1 1 - - - - YES 2 YES 2 YES 2- - - - NO YES 2 NO NO NO
TERM IP ADDRESS TERM IP ADDRESS
6.0 TERM IP ADDRESS TERM IP ADDRESS
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX
SUBNET MASK SUBNET MASK
7.0 SUBNET MASK SUBNET MASK
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX
GATEWAY IP ADDR GATEWAY IP ADDR
8.0 GATEWAY IP ADDR GATEWAY IP ADDR
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX
SAVE CONFIG Y/N SAVE CONFIG Y/N
9.0 SAVE CONFIG Y/N SAVE CONFIG Y/N
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE
This parameter specifies the Primary Host IP Address. By default, it is set to
117.120.34.110.
Press ENTER.
This parameter specifies the Primary TCP/IP Port Number of Paymark IP Host.
This parameter specifies the Secondary Host IP Address. By default, it is set to
117.120.32.110.
Press ENTER.
This parameter specifies the Secondary TCP/IP Port Number of Paymark IP Host.
Press the corresponding number key and press ENTER to set the IP address for the
terminal.
Option 1 – to allow the terminal to dynamically obtain its IP address and proceed
with step 7.0. By default option 1 is always selected
Option 2 – to enter in the static IP address for the terminal and proceed with step
4.0
Enter in the static IP address for the terminal.
Example: 192.10.1.14
Note: Press the FUNC key to insert a dot in between numbers.
Enter in the subnet mask for the static IP address.
Example: 255.255.255.0
Enter in the gateway IP address to forward the packets from.
Example: 192.10.1.1
Terminal prompts to save configuration. Press ENTER to save configuration on the
terminal or press CLEAR to exit and return to idle screen.
PAGE 30 OF 97
Version 1.3