Merchant Administration Functions; Terminal Totals - Ingenico 5100 Operating Manual

SKYZER TECHNOLOGIES

4.13 MERCHANT ADMINISTRATION FUNCTIONS

The following standard merchant administration functions are available:
NOTE: When set up as a multi-merchant device, the terminal will first prompt for
the selection of the particular merchant for each of the administration
functions above.
4.13.1

Terminal Totals

This function allows the merchant to determine the total count and amount of
all accepted transactions supported by the terminal since the totals where last
reset by the merchant.
Step Terminal Display Description
ADMIN ADMIN
1.0 ADMIN ADMIN
TOTL TOTL TOTL TOTL INQ INQ INQ INQ
1 Merchant 1 1 Merchant 1 1 Merchant 1 1 Merchant 1
2.0
2 Merchant 2 2 Merchant 2
2 Merchant 2 2 Merchant 2
3 Merchant 3 3 Merchant 3 3 Merchant 3 3 Merchant 3
PRINTING PRINTING
3.0 PRINTING PRINTING
RESET TOTALS? RESET TOTALS?
4.0 RESET TOTALS? RESET TOTALS?
ENTER=YES, CLR=NO ENTER=YES, CLR=NO ENTER=YES, CLR=NO ENTER=YES, CLR=NO
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE
Press ENTER until the ADMIN menu is shown on the display.
Press CHQ key to select TOTL.
CUT CUT CUT CUT
Only applicable with Multi-Merchant setup.
Select the corresponding number on the terminal to select the Merchant followed by
ENTER.
Totals will be printed immediately.
The user will be prompted whether the totals should be reset.
- If yes is selected, the terminal will return to idle and totals will have been reset. (To
check this, repeat steps 1-2. Totals should all appear as $0.00 on the printout.)
- If no is selected, terminal will return to idle without resetting the totals. (To check
this, repeat steps 1-2. Totals should remain the same.)
PAGE 79 OF 97
Version 1.3