Tcp-Ip (Broadband) Configuration Flowchart - Ingenico 5100 Operating Manual

SKYZER TECHNOLOGIES

3.1.4 TCP-IP (Broadband) Configuration Flowchart

START
From the idle screen
press FUNC and
then key in 3824
followed by the
ENTER
If TCP-IP is selected, the
Primary Host IP address
is set as default
117.120.34.110, press
ENTER.
Primary Host Port
number is set as default
to 33876, press ENTER.
The Secondary Host IP
address is set as default
117.120.32.110, press
ENTER.
Secondary Host Port
number is set as default
to 33876, press ENTER.
At the Enable DHCP Y/N, by
default is selected as 1-YES
and press ENTER, if the site
has DHCP
If the site has no DHCP
enabled, press 2-NO and
then press ENTER
NO
Manually key in the
Static IP address
•
Subnet Mask
•
Gateway IP
•
address
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE
Press ENTER at the
CONFIG PARAMS?
At the COMMS MODE,
press the corresponding
number key to select
preferred comms mode
and press ENTER
1-Dial-up
2-TCP-IP/Dial
3-TCP-IP
Save Config Y/N?
YES
Press ENTER to save
or CLEAR to exit
without saving
PAGE 24 OF 97
Key in the Terminal and
Merchant ID into the
terminal followed by
the ENTER.
Network Interface
Identifier (NII) by
default will be selected
as 001 and press ENTER
START TCP-IP Y/N?
Press ENTER to start
TCP-IP or CLEAR to exit
without starting TCP-IP
COMPLETED
Version 1.3