What To Do Next; Configuring Lldp; Lldp Default Configuration; Enabling Lldp Globally - Cisco 6000 Series Configuration Manual

What to Do Next

Command or Action
Step 6 show interfaces [TenGigE] interface-path-id
Example:
RP/0/RP0/CPU0:router# show interfaces TenGigE
0/3/0/0
What to Do Next
To attach Layer 2 service policies, such as quality of service (QoS), to the Ethernet interface, refer to the
appropriate Cisco IOS XR software configuration guide.

Configuring LLDP

This section includes these configuration topics for LLDP:

LLDP Default Configuration

This table shows values of the LLDP default configuration. To change the default settings, use the LLDP
global configuration and LLDP interface configuration commands.
Table 6: LLDP Default Configuration
LLDP Function
LLDP global state
LLDP holdtime (before discarding), in seconds
LLDP timer (packet update frequency), in seconds
LLDP reinitialization delay, in seconds
LLDP TLV selection
LLDP interface state

Enabling LLDP Globally

To run LLDP on the router, you must enable it globally. When you enable LLDP globally, all interfaces that
support LLDP are automatically enabled for both transmit and receive operations.
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
40
Purpose
• Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
(Optional) Displays statistics for interfaces on the router.
Default
Disabled
120
30
2
All TLVs are enabled for sending and receiving.
Enabled for both transmit and receive operations when
LLDP is globally enabled.
Configuring Ethernet Interfaces