Getting Started; Understanding The Display; Keypad Operation; Figure 5-1 Sm-Keypad - Emerson unidrive sp User Manual

Safety Mechanical
Product
Information information Installation
5

Getting Started

This chapter introduces the user interfaces, menu structure and security level of the drive.
5.1

Understanding the display

There are two keypads available for the Unidrive SP. The SM-Keypad has an LED display and the SM-Keypad Plus has an LCD display. Both
keypads can be installed on the drive but the SM-Keypad Plus can also be remotely mounted on an enclosure door.
5.1.1 SM-Keypad (LED)
The display consists of two horizontal rows of 7 segment LED displays.
The upper display shows the drive status or the current menu and
parameter number being viewed.
The lower display shows the parameter value or the specific trip type.

Figure 5-1 SM-Keypad

Upper display
Lower display
Control buttons
Fwd / Rev (blue) button
Stop/reset (red) button
Start (green) button
The red stop
NOTE
Both the SM-Keypad and the SM-Keypad Plus can indicate when a SMARTCARD access is taking place or when the second motor map is active
(menu 21). These are indicated on the displays as follows.
SMARTCARD access taking place
Second motor map active
5.2

Keypad operation

5.2.1 Control buttons
The keypad consists of:
1. Joypad - used to navigate the parameter structure and change parameter values.
2. Mode button - used to change between the display modes – parameter view, parameter edit, status.
3. Three control buttons - used to control the drive if keypad mode is selected.
4. Help button (SM-Keypad Plus only) - displays text briefly describing the selected parameter.
The Help button toggles between other display modes and parameter help mode. The up and down functions on the joypad scroll the help text to
allow the whole string to be viewed. The right and left functions on the joypad have no function when help text is being viewed.
The display examples in this section show the SM-Keypad 7 segment LED display. The examples are the same for the SM-Keypad Plus except that
the information displayed on the lower row on the SM-Keypad is displayed on the right hand side of the top row on the SM-Keypad Plus.
72
Basic
Electrical Getting
Installation Started parameters
Mode (black) button
Joypad
button is also used to reset the drive.
The decimal point after the fourth digit in the
upper display will flash.
The decimal point after the third digit in the
upper display will flash.
www.controltechniques.com
Running SMARTCARD
Optimization
the motor operation
5.1.2 SM-Keypad Plus (LCD)
The display consists of three lines of text.
The top line shows the drive status or the current menu and parameter
number being viewed on the left, and the parameter value or the specific
trip type on the right.
The lower two lines show the parameter name or the help text.

Figure 5-2 SM-Keypad Plus

Control buttons
Fwd / Rev (blue) button
Stop/reset (red) button
Start (green) button
SM-Keypad
Onboard Advanced Technical
Diagnostics
PLC parameters Data
SM-Keypad Plus
The symbol 'CC' will appear in the lower left
hand corner of the display
The symbol 'Mot2' will appear in the lower left
hand corner of the display
Unidrive SP Free Standing User Guide
UL Listing
Information
Mode (black) button
Help button
Joypad
Issue Number: 1