Application > Proprinter Setup - Printronix T6000 Administrator's Manual

Application > Serial Matrix Setup > Printer Select
Determines if control codes DC1 and DC3 will ignored or used to disable or
enable the printer, respectively.
Disable
Enable
Factory Default
Application > Serial Matrix Setup > Alt. Set 80-9F
Determines how data in the range 80 hex – 9F hex will be treated.
Control Code
Printable
Factory Default
Application > Serial Matrix Setup > ESC d Command
This item is for backward compatibility.
Even dot plot
Double high
Factory Default
Application > Proprinter Setup
IMPORTANT
The Proprinter Setup submenu will only be present when the LP+ Emulation
menu is set to Proprinter XL. Otherwise, this menu will be replaced with the LP+
Emulation menu.
Application > Proprinter Setup > Character Group
This option selects the Character Set Group. Based on the group selected,
then the character set can be chosen with the menu following XXX Sets. The
group Standard Sets is shown below because it is unique to Proprinter. All
other groups are similar and described in LP+, PGL, VGL Character Sets
Ignores the ASCII DC1 and DC3 control codes.
Disables the printer when control code DC1 is received
and enables the printer when DC3 is received.
Disable
Interprets as a control code.
Prints data in this range.
Control Code.
This option interprets the ESC d command as even dot
plot.
This option interprets the ESC d command as double
high. Select this option for backward compatibility.
Even dot plot.
159