Media > Handling - Printronix T6000 Administrator's Manual

Media > Handling
This option specifies the type of printing to be done.
Transfer
Direct
Factory Default
This option specifies how the printer will handle the media (labels or tag
stock).
Tear-Off Strip
Peel-Off
Cut
Continuous
Factory Default
62
Media > Handling > Print Mode
Indicates Thermal Transfer printing (ribbon installed).
Indicates Direct Thermal printing (no ribbon) and
requires special heat sensitive media.
Transfer
Media > Handling > Media Handling
Printer prints on the media and sends it out the front
until the print buffer is empty, then positions the last
label over the tear bar for removal.
Prints and peels die-cut labels from the liner without
assistance. The printer waits for you to take away the
label before printing the next one (on-demand
printing). When the optional internal rewinder is
installed with liner attached, a "Remove Label"
message will display to remind you to remove the label
before the next one can be printed. See Label Peel-Off
page 30 and Media > Handling > Peel Present table
page 64 for more information.
Not allowed if the cutter is installed. The error message
"INCOMPATIBLE WITH CUTTER" displays.
When the optional media cutter is installed, it
automatically cuts media after each label is printed or
after a specified number of labels have been printed
when a cut command from the host has been issued. It
cuts continuous roll paper, labels, or tag stock.
Only allowed when the cutter is installed. The error
message "OPTION NOT INSTALLED" displays
otherwise.
Printer prints on the media and sends it out the front.
See Media > Handling > Continuous Mode table page
63 for more information.
Tear-Off Strip