Host Io > Centronics - Printronix T6000 Administrator's Manual

Host IO > Centronics
IMPORTANT
This submenu will not be available unless the parallel option card is installed.
This option configures the amount of memory allocated for the Ethernet
buffer incremented in 1 Kbyte increments.
Minimum
Maximum
Factory Default
This option determines how the printer will operate if the host asserts a
prime signal.
Disable
Enable
Factory Default
This option determines if TOF is sought after a reboot of the printer due to
the host asserting a prime signal.
Reset
Do Nothing
Factory Default
170
Host IO > Centronics > Buffer (Kbytes)
1
16, 32, or 64
16 Kbytes
Host IO > Centronics > Prime Signal
The printer will not reboot if the host asserts the Prime
Signal.
The printer will reboot if the host asserts the Prime
Signal.
Disable
Host IO > Centronics > TOF Action
A form feed is performed before a warm start when the
prime signal is asserted from the host. This setting is
used only if the prime signal parameter is enabled.
Nothing occurs before a warm start when the prime
signal is asserted from the host.
Reset