Printronix T6000 Administrator's Manual page 286

Command
FILE_IO CAPTURE
(DISK_IO)
DRIVE
PROPS
DEL
RUNFILE
UPLOAD
MAXSIZE
286
Table 27. General PTX_SETUP Commands
Sub-Command
Filename
Letter
File;Prop
Filename
File;Prop
File;Port
Kb
Parameter
Captures all incoming data into a file
named Filename. Receipt of a
FILE_IO–CAPTURE command
without the Filename parameter will
force the file data to be written to
flash, and will end the file capture.
The drive letter chooses between
the Flash File System and the SD
Card. No drive letter or the drive
letter A selects the Flash File
System. The drive letter B selects
the SD card.
The PROPS command will set the
file properties of a given file. The file
properties are a four letter, case
sensitive file descriptor. The
properties field can be used to
ensure that a file is used for its
intended purpose. Once properties
have been associated with a file,
they cannot be changed.
The DEL command will mark a file
as deleted. The space the file
occupied will be freed the next time
the printer is powered up.
The RUNFILE command will open
the file named File for printing. After
the PTX_END command is
processed, the contents of File will
get printed before any more data is
read from the host. If the Prop field
is present, RUNFILE will verify that
Prop matches the saved file
properties. Any mismatch will cause
the command to be ignored.
Reads the file named File out of the
flash file system and sends it to a
host computer via the Port I/O port.
Port is either 1284 (for reverse
nibble or byte mode transfer using
the parallel port), or SERIAL.
NOTE:
installed, 1284 is used to upload
across the network.
For backwards compatibility.
Description
if the Ethernet option is