Using Ccm To Configure A Printer - Printronix T6000 Administrator's Manual

5. Download the configuration files to the printer. These must be downloaded to the printer in a specific
order per the table below. All files need to be sent sequentially (e.g. in a batch file) in order to avoid
having the download process timeout before all files have been received by the printer.
D/L Order
1 Printer Program File
2 Feature File
3 CST File
4 Download Font
5 Download Customer File
6 NIC Configuration File
7 Customer File(s)
8 PTX_SETUP Config File
6. As the printer is downloading it will display "Downloading File – xxx" for each file, including those that
are contained in the Program File.
7. When the CCM has completed the programming process, the printer will display

Using CCM To Configure A Printer

CAUTION
You must power off the printer before you install or remove the SD card. If you
remove the SD card after powering on the printer, the fault message "SD
REMOVED Reboot Printer" will display. You cannot clear this message by
reinserting the SD card. You must cycle power.
1. Set the printer power switch to O (Off).
2. Insert a programmed CCM SD card into the printer's SD slot.
3. Turn the printer power on and the following message will be displayed on the front panel:
298
File Types D/L Header
Max. Number
Allowed
Yes 1
Yes 1
Yes 1
Yes 1 or more
Yes 1 or more
Yes 1
No 1 or more
No 1 or more
Restrictions
Must not be zipped
(Factory default e.g.PGL)
Default SFCC (Factory)