Printronix T6000 Administrator's Manual page 255

Displayed Message
LABEL MISSING
Check Paper Path
Table 13. LCD Message Troubleshooting
The Label Taken Sensor did not detect the label present over the
tear bar with Peel-Off Media Handling mode enabled.
•
The label was removed before the printer stopped printing or
before the LCD "Remove Label" message displayed.
•
The label slipped behind the platen roller.
•
The label wrapped around the platen roller.
•
Peel-Off Media Handling mode was mistakenly selected.
1. Press the PAUSE key to continue printing and then wait for
the LCD "Remove Label" message before removing the label.
2. Open the pivoting deck, reinstall the label, close the deck,
press the PAUSE key, and continue printing.
3. Open the pivoting deck and remove wrapped labels from the
platen. Clean all adhesive from the platen. Reinstall labels,
close the deck, press the PAUSE key, and continue printing.
4. Select the correct Media Handling mode in the Media >
Handling section.
Solution/Explanation
255