Ptx_Setup Download; Manual Two-Key Download - Printronix T6000 Administrator's Manual

PTX_SETUP Download

Use PTX_SETUP to load files into the Main File System. Refer to the Appendix section entitled "The
PTX_SETUP Commands" on page 282.
Example loading a font named ARIAL.TTF:
!PTX_SETUP
FILE_IO-CAPTURE;"ARIAL.TTF" PTX_END
Arial TrueType font binary data.
NOTE
: DO NOT add LF/FF to the end of the binary data.
!PTX_SETUP
FILE_IO-CAPTURE;"" PTX_END

Manual Two-Key Download

1. Start a Windows Command Prompt session.
2. Navigate to the directory with the target file (e.g., c:\download).
3. Copy cnvt2fls.exe from the
the target file.
4. Convert the file to a downloadable format using the following command at the command prompt:
cnvt2fls file_name1 file_name2 file_name3 A FONT <Enter>
where
•
file_name1 is the name of the file to be converted into the downloadable format.
•
file_name2 is the name of the file of the output file that will be downloaded into the printer.
•
file_name3 is the name of the file within the Main File System.
The FONT parameter should only be used with fonts; otherwise, omit this parameter. For example:
cnvt2fls arial.ttf arial.dwn ARIAL.TTF A FONT <Enter>
This creates file "arial.dwn" that will place "ARIAL.TTF" into the Main File System.
5. Place the printer in download mode as described in Manual Two-Key Download Sequence on page
215
6. Send the file as described in Sending Firmware in Download Mode on page 216. Substitute file_name2
in place of the firmware FILENAME.prg.
7. The process is complete when the file successfully loads into flash and the printer resets.
8. To verify that the file is recognized and downloaded, go to the System > Flash File View submenu. One
of the files displayed should include file_name3.
222
Figure 13 File Download Notification
http://PrintronixAutoID.com/support/drivers/ website to the directory with