Printronix T6000 Administrator's Manual page 76

Calibration activities when the printer is powered up.
Disable
Auto-Cal
Seek TOF
Factory
IMPORTANT
Selects whether the printer performs a selected action after a print head open
fault condition is cleared.
Disable
Auto-Cal
Seek TOF
Factory
IMPORTANT
76
Sensors > Calibrate > Power-Up Action
No activities at power up.
Auto Calibrate is performed at power-up. Once the
Auto Calibrate is complete, the printer will momentarily
display the Sensed Distance determined by the Auto
Calibrate.
Assumes user has already calibrated media and used
gap/mark sensor. This moves the media to
Top-of-Form at power up if Sensors > Control >
Gap/Mark Sensor is not set to Disable.
Auto-Cal
If Media > TOF >Ticket Save Mode is set, Auto-Cal
and Seek TOF will not be performed.
SENSORS > Calibrate > HeadClose Action
No media motion after a print head open fault condition
is cleared.
Performs Auto Calibration every time the print head
open fault condition is cleared.
Moves the media to TOF (Top Of Form) when the
printhead is closed unless Sensors > Control >
Gap/Mark Sensor is set to Disable.. The media should
already be calibrated using Gap/Mark sensor.
Disable
If Media > TOF > Ticket Save Mode is set, Auto-Cal
and Seek TOF will not be performed.
If there is data pending (data in buffer) when the
head open fault is cleared, Auto-Cal and Seek TOF
are ignored.