Printronix T6000 Administrator's Manual page 284

Command
CONFIG PRINT
DELETE
UPLOAD
DOWNLOAD
OVERLAY
RESET
GET_NAMES
SET_NAME
CLEAR_NAMES
MPI_SELECT
284
Table 27. General PTX_SETUP Commands
Sub-Command
Cfg
Cfg
Port;Cfg
Cfg
Cfg
"Port"
Cfg
MPI
Parameter
Print Configuration Cfg. Cfg can be
a number 1-8, or one of four pre-
defined configurations. The four
non-numeric configurations are
requested using the first character
for the CURRENT, FACTORY,
POWERUP, or ALL configuration(s).
Deletes Configuration number Cfg.
Cfg must be in the range of 1-8.
This command uploads the
configuration stored in location Cfg
to the port specified by Port. Port
must either be 1284 or SERIAL. Cfg
may be 1-8 or ALL.
This command saves the
configuration data that follows as
configuration Cfg. Cfg must be 1-8
or END.
This command overlays the
configuration data that follows on
existing configuration Cfg. Cfg must
be 1-8 (or END). If Cfg does not
exist then command is treated the
same as DOWNLOAD.
Reboots the printer.
This command uploads the names
of the configurations to the port
specified by Port. Port must either
be "1284" or "SERIAL".
This command downloads a name
for the configuration specified by
Cfg. Cfg must be 1-8.
This command resets all of the
configuration names to their default
values.
This command selects the active
Management Protocol Interface
(MPI). Currently there are two
selections "UCP" and "PXML".
Description