Printronix T6000 Administrator's Manual page 64

This feature allows you to select which part of a label gets presented to the
peel bar.
Next TOF
End of Form
End of Image
Factory Default
IMPORTANT
IMPORTANT
64
Media > Handling > Peel Present
Media is moved to next TOF after image printing
before presenting media to the peel-off position. This
option is for standard labels where the gap/mark length
is less than the printhead to peel bar distance (about
1/2 inch).
Media is moved to the end of form after image printing
before presenting media to the peel-off position. This
option is for labels that have wide gaps that result in
labels falling off the peel bar. This setting works with
non-mark media where the end of form is not the same
as the next TOF. This setting is useful for die cut labels
where the physical bottom of the label can be detected
by the media sensor.
Image prints and media moves to peel-off position.
This option is for labels that have wide gap/marks that
result in labels falling off the peel bar. This selection is
intended for cases where presenting the next TOF or
end of form still results in labels falling off the peel bar.
This menu selection works best if the length of the
image printed matches the physical length of the label.
Next TOF
This menu only visible when the peel option is
installed.
End of Image selection is affected by the Media >
Image > Clip Page option.