Printronix T6000 Administrator's Manual page 252

Displayed Message
FILE SYS FULL
Delete Files
FILE SYS FULL
Optimize&Reboot
FILE SYS INVALID
Optimize&Reboot
FILE SYS WRITE
Check Flash
FILE UPLOADING
Please Wait
FPGA FILE NOT FOUND
FRAMING ERROR
252
Table 13. LCD Message Troubleshooting
Insufficient flash memory available to store file. Given there is
512MB of Flash Memory, this error is still possible but unlikely.
1. Go to the System > Flash File Edit section of the menu.
2. Check the amount of flash memory that can be optimized from
the "Flash Reclaimable" menu.
3. If this value is small, then use "Delete Files" to delete
unwanted files.
4. If this value is large, then run "Optimize & Reboot".
File system not detected or flash was corrupted.
1. Run the System > Flash File Edit > Optimize & Reboot
feature.
The file system was given an invalid request.
1. Run the System > Flash File Edit > Optimize & Reboot
feature.
Problem writing to flash memory.
1. Power off the printer for 15 seconds, then power back on. If
the problem persists, contact your authorized customer
service representative.
File is uploading to PNE.
1. Wait for upload completion before accessing printer front
panel.
The program file was not downloaded successfully.
1. Download the program file again.
2. If the message reappears, contact your authorized customer
service representative.
Serial framing error over a serial interface.
1. Match the serial interface settings of the printer to those of the
host computer.
Solution/Explanation