Tools > Statistics - Printronix T6000 Administrator's Manual

This turns on the hex dump diagnostic. See Chapter 6 Diagnostics and
Troubleshooting page 232 for more information.
Disable
Enable
Factory Default
This provides an automatic capture of debug information when a processor
fault occurs. This makes it easy for users (or field engineers) to capture a
failure without having to wait for it to occur. Once it occurs, the file can be
easily uploaded from the printer FLASH memory using the NIC webpage or
PrintNet Enterprise Suite. Once acquired, it can be sent to Printronix
Customer Support.
Disable
Enable
Factory Default
IMPORTANT
Tools > Statistics
All of the menus shown here are read-only.
Displays the cumulative time in hours the printer has been powered on. This
value is set to zero at the factory.
Displays the cumulative number of inches the printer has moved media. This
value is set to zero at the factory.
Tools > Diagnostics > Hex Dump Mode
Hex dump mode is turned off.
Hex dump mode is turned on and all incoming data will
be printed in hexadecimal format.
Disable
Tools > Diagnostics > Auto Dump
Auto dump mode is turned off.
A dump file is automatically created and stored in
FLASH memory as "autodbg1.dbg" or "autodbg2.dbg"
when the processor fault occurs.
Enable
Once a file is stored in FLASH, it will not be
replaced with a new file if another problem occurs.
This is done to prevent FLASH memory from filling
over time.
Tools > Statistics > Printer On Time
Tools > Statistics > Total Media Dist
203