Printronix T6000 Administrator's Manual page 254

Displayed Message
Half Speed Mode
HEAD POWER FAIL
IGP/PGL ERROR
INCOMPATIBLE WITH
CUTTER
254
Table 13. LCD Message Troubleshooting
The printhead or power supply is approaching a hot state. Half
Speed Mode helps the cooling process and should permit
completion of print jobs. Half Speed Mode helps prevent a PRINT
HEAD HOT or PWR SUPPLY HOT fault, which will stop the printer
1. Allow printer to continue printing. Full speed will resume
automatically when a lower printhead or power supply
temperature is achieved.
2. Let the printer cool down. Full speed will be restored when
printing is resumed.
3. Lower Media > Image > Print Intensity and Media > Speed >
Print Speed to reduce frequency of Half Speed Mode.
Printhead lost power
1. Replace the printhead.
2. Power off the printer for 15 seconds, then power back on
again.
3. If the problem persists, contact your authorized customer
service representative.
Appears when the "Fault" option is selected from Error Report in
the front panel and there is an application programming error with
the IGP emulation PGL
1. Correct the application programming error as described in the
PGL Programmer's Reference Manual.
2. The other option is to modify Application > PGL Setup > Error
Report menu.
Peel-Off Media Handling selection was attempted with the cutter
option still installed. These modes require that the Peel option be
installed to use the Label Taken Sensor
1. Select a different Media Handling Mode.
2. Power off the printer and remove the cutter option, install
the Peel option, power on the printer and select Peel-Off
Mode.
Solution/Explanation
.
.
.
.