Pcie Riser Board - HPE ProLiant DL560 Gen9 Maintenance And Service Manual

Remove the riser cage.
6.
To replace the component, reverse the removal procedure.

PCIe riser board

WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some
internal circuitry remain active until AC power is removed.
To remove the component:
Power down the server (on page 28).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 27).
3.
Remove the access panel
4.
Remove the PCIe riser cage
5.
Remove any expansion board installed in the slot
6.
("Access panel" on page 31).
("Primary 3-slot PCI riser
("Expansion
cage" on page 33).
boards" on page 60).
Removal and replacement procedures 34