Quick Setup (Qset); Circuit Condition Display (Lmon) - Panasonic KX-TVP200 Installation Manual

7.2 UTILITY COMMANDS
$ HELP
OFLN
ONLN
PASS
TIME
PSET
ELOG
SAVE
LOAD
GPRN
VERS
CREP [no.]
CCLR [no.]
MWL
MRL
MPLT [opt]
QSET
LMON
PUTD
WCID
$

7.2.17 Quick Setup (QSET)

Use the QSET command initially to perform a basic setup of your VPS when you use your VPS
for the first time or after system initialisation.
Note
Quick setup requires VT100 emulation software.
Type QSET, then Press RETURN.

7.2.18 Circuit Condition Display (LMON)

Use the LMON command to display the circuit condition every 1.5 s. To turn off this command,
enter [\].
The following circuit conditions may be displayed.
"Ready"
"Incoming Call"
"Outgoing Call"
"DSP Reset"
"PT connect"
"Error"
160 Installation Manual
: System Off-line
: System On-line
: Password setting
: Time & Date setting
: Report Print Out Time setting
: Device Error Log Listing
: VPS Program & Date Save (VPS —> PC : Xmodem)
: VPS Program & Date Load (VPS <— PC : Xmodem)
: Parameter Global Printing (only 'ASCII Terminal' mode)
: Program Version Check
: Custom Menu Information List
[no.] : Custom Menu No. (1-100)
: Custom Menu Access Counter Clear
[no.] : Custom Menu No. (1-100/0) (0: Clear All)
: MWL Retry count Set (1-3)
: Minimum Recording Length Set (0-3)
: Registered User Prompt No. List
[opt] : 1 —> User Prompt 1
2 —> User Prompt 2
None —> User Prompt 1&2
: Quick Setup
: Line Monitor
: DTMF Information Display (Don't leave enabled after
troubleshooting.)
: Wait Time for Caller ID
: Waiting for a call
: Answering a call
: Making an outbound call
: Processing DSP reset
: Processing PT connect
: DSP Card is not loaded