Panasonic KX-TVP200 Installation Manual page 19

KX-TVP204 transmits and receives ONLY digital signals with a Panasonic KX-TD Digital PBX.
The DSP has the same features as the KX-TVP102.
MODE (Rotary Switch):
(Check the status of this switch only at start-up.) Provides the following additional functions:
Table 1-1
Position
0
1
2*
3*
4
5
6
7
8
9
* For Panasonic KX-TD series telephone systems with DPT Integration
To change the position, use an electrical or jewellers screwdriver etc.
When setting the Rotary Switch to any position (except 0):
1. Disconnect the extension wire(s) and wait a few minutes.
2. Turn the power switch off at the VPS.
3. Set the Rotary Switch.
4. Turn the power switch back on at the VPS.
5. Connect the extension wire(s) to the VPS and wait approximately 5 min.
6. Return the Rotary Switch to position 0.
Hard Disk Drive:
(One/system) Stores the proprietary system programme, the system administration table, the
voice prompts (about 50 min worth) and has the recording area for the messages from callers.
(The hard disk is controlled by the central micro processor.)
Additional Function
Normal setting.
Initialises RS-232C parameters.
RS-232 default parameters: 9,600, N, 8, 1
Auto Configuration is automatically completed and
all ports are set for Automated Attendant service.
Auto Configuration is automatically completed and
all ports are set for Voice Mail service.
Reserved
Initialises the VPS. Clears all voice data (except
User 1 and User 2 prompts) and returns all system
parameters to the default setting.
Test Mode (Hard Disk Drive Read/Write Test)
Adjust VPS parameters to your PBX quickly.
Initialises the VPS. Clears all voice data and
returns all system parameters to the default
setting.
CAUTION: User 1 and User 2 Prompts will be
erased!
Reserved
1.3 SYSTEM BASICS
Installation Manual 19