Panasonic KX-TVP200 Installation Manual page 256

Voice processing system
Hide thumbs Also See for KX-TVP200:
Table of Contents

Advertisement

B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
Table B-29
Parameter
Number of
Digits
to Access
Outside Line
Call Transfer
No Answer
Time
Outgoing Call
No Answer
Time
Pause Time
Outgoing Call
Setup
Sequence
256
Installation Manual
Value Range
(Default)
0-8 digits
Specifies the number of digits necessary to access an
(1)
outside (CO) line.
Example:
If the PBX requires callers to dial "9" to access an
outside (CO) line, this parameter should be set as "1".
This enables the system to recognise that an outgoing
call setup sequence is completed once the initial "9"
has been dialled (9-123-4567). The full sequence is
therefore: 9-(outgoing call setup sequence)-123-4567.
The VPS can discriminate between local and long
distance calls and can report outgoing calls and calling
times for billing purposes on periodic port usage
reports.
10-60 s
Specifies the length of time that the VPS must wait
(20)
before retrieving the transferred call when there is no
answer at the destination extension.
Note: Make sure that the duration of Call Transfer No
Answer Time is longer than the duration of Call
Forwarding No Answer Time at the PBX. Otherwise,
the PBX may forward the call (transferred by the VPS)
immediately to its destination without leaving enough
time to answer the call.
10-90 s
Specifies the length of time that the VPS must wait
(30)
before concluding that there is no answer at the
outside number called.
1-9 s
Specifies the pause time between dialled digits.
(2)
Up to 12 digits
Specifies the sequence of codes used by the VPS
consisting of
when calling an outside (CO) line. You can set up to 12
digits. The default value is "T". "T" indicates that the
0-9, , #, F, R, S, T,
system will dial the telephone number only after
W
detecting a dial tone.
(T)
Example:
9W = (9) - 2-s wait - dial telephone number. "9" is the
outside (CO) line access number.
F: Flash (Recall)
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
1-9, 0, , #: Dial Codes
Description/Function

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents