Set Time (Time) - Panasonic KX-TVP200 Installation Manual

7.2 UTILITY COMMANDS
3.
To create a password or change an existing password:
a) Type [1] or [2]
Maximum 10 characters
NEW PASSWORD : =
b) Type the password.
VERIFICATION: =
c) Type the password again for verification.
4.
To clear a password:
a) Type [1] or [2].
Maximum 10 characters
NEW PASSWORD : =
b) Press ENTER. Do not type a password on this screen.
VERIFICATION : =
c) Press ENTER. Do not type a password on this screen.

7.2.4 Set Time (TIME)

Use the TIME command to set the system date and time. A number of system functions require
that the system time and date be set correctly. These functions include message waiting
notification, external message delivery, call-retries-after initial-failure-to-connect, and
automatic deletion of messages.
Time Synchronisation: If you have DPT Integration between the VPS and your PBX (latest
software version), the date and time are automatically sent from the PBX to the VPS whenever
the PBX sets the date and time. Also, this transfer occurs whenever DPT Integration is
established.
1.
Type TIME, then Press RETURN.
$ TIME
Current time is 12:34, PM
2.
Type the current time.
Current date is MON 1-JAN-2001
Enter new date (DD-MM-YY) : =
150 Installation Manual
Note
When you press [2] to change the System Reset/Clear password, you should
type the current (OLD) password before entering a new one.
Note
The password entered on the screen will not appear. The VPS does not
distinguish capitals from lower cases.
Enter new time (HH:MM, AM/PM) : =