Panasonic KX-TVP200 Installation Manual page 152

7.2 UTILITY COMMANDS
$ ELOG
Note
The following tables display and explain the errors that the system can identify.
Table 7-2 Device Error Log Indications
CPU
CLOCK
DISK
DSP*
DSP*
CPU
* = port number (1-12)
Examples of a terminal display when errors are generated:
Table 7-3 Error Indications at System Startup
ROM ERROR: Sum Error!!
DISK ERROR: Initialize Error!!
DISK ERROR: No System!!
DISK ERROR: Program Load Error!!
DISK ERROR: Program Sum Error!!
152 Installation Manual
DEVICE ERROR
1. CPU MEM-GET
2. CLOCK
3. DISK DATA R/W (xx:yyyy)
4. DSP* SCAN
5. DSP* FIFO
6. CPU APPLICATION (x)
* = port number (1-12)
Indication
MEM-GET
DATA R/W (xx:yyyy)
SCAN
FIFO
APPLICATION (x)
Indication
TIME
14-JUL 2:00 PM
14-JUL 2:00 PM
14-JUL 2:00 PM
14-JUL 2:00 PM
14-JUL 2:00 PM
14-JUL 2:00 PM
Meaning
CPU board software memory acquisition error.
CPU board is short of memory temporarily
because of too much traffic.
Clock access error. Clock IC is out of order.
Check the hardware.
HDD access error. If there is a sector that often
causes errors, check the disk.
xx : IDE error code
yyyy : read/write error sector number
DSP-SCAN error. DSP is out of order. Check the
hardware.
DSP/FIFO error. During the system is handling
calls, there was a temporary problem with the DSP
and FIFO memory.
Application error. While the system is handling
calls, temporary application error occurs.
x: port number
ROM checksum error.
HDD initialisation error.
No system HDD present.
Programme could not be loaded from system
HDD.
Checksum error in programme loaded from
system HDD.
Meaning