Panasonic KX-TVP200 Installation Manual page 84

4.2 KX-TD500 PROGRAMMING FOR DIGITAL INTEGRATION
Table 4-2
The PBX is not programmed properly to support
DPT Integration.
10.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER. All parameters can be set through the menu-driven programme.
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100
Please Enter the Number := ______
11.
Go to the System Administration Top Menu. Select [5] and Press ENTER, or Type [3] then
QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.
TEST: Press the INTERCOM button and then [2065]. If the VPS
answers, you have a DPT connection.
Set the Rotary Switch to position 0 after initialisation is complete.
84 Installation Manual
Cause
When the System Administrator starts operation, the system asks for the terminal
type. By choosing VT100 [2], all parameters can be set through the menu-driven
programme.
Please Enter the Number:= [2]
Select [2] because Quick Setup is only available when using a personal computer
that can emulate a VT100 terminal.
Remedy
Do required integration
programming as described in
this chapter.