7.2 UTILITY COMMANDS
to execute this command for all the data selected. When performing this operation, always wait
until the process completion indication appears.
WARNING
Never save (back-up) and upload the "Program" without your dealer's
support.
The memory required to save each data component is indicated below.
1. Program—approximately 2 Mbytes (See Warning above)
2. Parameters—approximately 4.4 Mbyte (System Configuration)
3. System Prompts—approximately 23 Mbytes (Do not save—prompts are
saved as defaults in the drive)
Saving items 4-7 below will depend upon the length of the recorded messages.
4. User Prompts-1 (Modified prompts—Modifications to default settings)
5. User Prompts-2 (Modified prompts—Modifications to default settings)
6. Custom Service Menus (Custom service recordings)
7. Personal Greetings (Subscriber greetings)
8. Company Greetings
1.
Type SAVE, then Press RETURN.
$ SAVE
VPS Disk Data Save (VPS -> PC : Xmodem)
1: Program
2: Parameters
3: System Prompts
4. User Prompts-1
5. User Prompts-2
6. Custom Service Menus
7. Personal Greetings
8. Company Greetings
Selection No. :=
2.
Select item to be backed up, then Press RETURN. The size of the file will be displayed.
To start press 'RETURN'
3.
Press RETURN.
- - - - - - SAVE Start!!
4.
Perform a Standard File Transfer. Set the data terminal to the receiving (Answer) mode
(Xmodem) and specify the backup filename. The specified data will be transmitted to the
data terminal.
Notes
•
The data terminal that you use must be equipped with communications software
that supports the Xmodem file transfer protocol. The command can be cancelled
by Typing [\] before entering the receiving mode. Once the receiving mode has
been selected, use the cancel command of the communication software being
used.
154
Installation Manual