Table B-34
Parameter
Intercom
Paging
Sequence
Release for
Intercom
Paging
No Answer
Time for
Intercom
Paging
Announcement
Repeat Cycle
Intercom
Paging Retry
Paging Code
for Group 1-16
Paging Code
for All Groups
Other Parameters-Fax Management
You can program the VPS to automatically forward incoming fax calls to a fax extension. You
can specify a maximum of 2 fax extensions as the destination for the Automatic Fax Transfer.
B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
Value Range
(Default)
Up to 12 digits con-
Specifies the intercom paging sequence required by
the PBX. This can be programmed using up to 12 of
sisting of 0-9, , #
the following 8 letters and 12 dial codes.
and special codes
(FXW)
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Pager Dialling
A: Answer
1-9, 0, , #: Dial Digits
Up to 12 digits con-
Specifies the intercom paging release code required
by the PBX. This can be programmed using up to 12 of
sisting of 0-9, , #
the 8 letters and 12 dial digits as specified above.
and special codes
(FW)
1-30 s
Specifies the length of time (in seconds) the VPS must
(5)
wait before concluding Intercom Paging when there is
no answer.
The VPS will return to the caller if the paged party does
not respond before this timer expires.
1-3 times
Specifies the number of times to announce the
(1)
intercom page.
Example:
"I have a call for (mailbox owner's name)".
1-10 times
Specifies the number of times to retry paging when the
(2)
paging destination is busy or if there is no answer.
Note: This setting applies only when the subscriber
has enabled "Intercom Paging" in Incomplete Call
Handling Status.
Up to 12 digits
Specifies the intercom paging access code required by
consisting of
the PBX.
0-9, ,# for each
group
Note: The Intercom Paging Group Number available
(None)
for each subscriber is determined on a COS-by-COS
basis.
Description/Function
Installation Manual
261