Wait For Caller Id (Wcid) - Panasonic KX-TVP200 Installation Manual

7.2 UTILITY COMMANDS
Sample display:
$ PUTD
Target Port for Debug : * * * * * * * * * * * *
Don't leave enabled after troubleshooting.
$
[1] DTMF:3
[1] DTMF:8
[1] A.Attend
[1] DTMF:#
[1] DTMF:6
[1] Voice Mail
[1] DTMF:1
[1] DTMF:0
[1] DTMF:1
[1] NonSub Svc
[1] * * *
[1] DTMF:#
[1] DTMF:9
[1] Thank you
WARNING
"PUTD" is a command originally used when troubleshooting. Do not use this
command for any other purpose. Do not disconnect the RS-232C connection
while the "PUTD" command is enabled. This could cause data overflow.

7.2.20 Wait for Caller ID (WCID)

Use the WCID command to specify the length of time (in seconds) the VPS must wait for the
Caller ID after the VPS has received the incoming call from the PBX.
If Caller ID is not needed at all, set the waiting time to "0" to accelerate the VPS response to
incoming calls.
Type WCID, then Press RETURN.
$ WCID
WAIT TIME FOR CALLER ID (5 sec) [0-60 sec] : = 0
$
162 Installation Manual