Default Settings After Initial Switch Configuration - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Default Settings After Initial Switch Configuration

•
•
•
Layer 3 VPN Services
These features are available only when the switch is running the metro IP access image.
•
•
Monitoring Features
•
•
•
•
•
•
•
•
•
Default Settings After Initial Switch Configuration
The switch is designed for plug-and-play operation; you only need to assign basic IP information to the
switch and connect it to the other devices in your network. If you have specific network needs, you can
change the interface-specific and system-wide settings.
For information about assigning an IP address by using the CLI-based setup program, see the hardware
Note
installation guide.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
1-8
Protocol-Independent Multicast (PIM) for multicast routing within the network, allowing for
devices in the network to receive the multicast feed requested and for switches not participating in
the multicast to be pruned. Includes support for PIM sparse mode (PIM-SM), PIM dense mode
(PIM-DM), and PIM sparse-dense mode
Multicast Source Discovery Protocol (MSDP) for connecting multiple PIM-SM domains
DHCP relay for forwarding UDP broadcasts, including IP address requests, from DHCP clients
Multiple VPN routing/forwarding (multi-VRF) instances in customer edge devices (multi-VRF CE)
to allow service providers to support multiple virtual private networks (VPNs) and overlap IP
addresses between VPNs
VRF and EIGRP compatibility
Switch LEDs that provide port- and switch-level status
MAC address notification traps and RADIUS accounting for tracking users on a network by storing
the MAC addresses that the switch has learned or removed
Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) for traffic monitoring on any port or
VLAN
SPAN and RSPAN support of Intrusion Detection Systems (IDS) to monitor, repel, and report
network security violations
Four groups (history, statistics, alarms, and events) of embedded RMON agents for network
monitoring and traffic analysis
Syslog facility for logging system messages about authentication or authorization errors, resource
issues, and time-out events
Layer 2 traceroute to identify the physical path that a packet takes from a source device to a
destination device
Time Domain Reflector (TDR) to diagnose and resolve cabling problems on copper Ethernet 10/100
ports
SFP module diagnostic management interface to monitor physical or operational status of an SFP
module
Chapter 1 Overview
78-17058-01