Configuration Requirements For Lucent 5Ess Custom Switch; Point-To-Point Configuration - Cisco 761M Installation Manual

Table C-7
Parameter
Router software
Switch type
SPIDs
Directory number
1 This parameter is not set with a software command.
2 The Cisco 765, Cisco 766, Cisco 775, and Cisco 776 require two SPIDs so that the basic telephone service
ports (POTS) operate correctly.

Configuration Requirements for Lucent 5ESS Custom Switch

This section describes the router configuration requirements when using Cisco 700 series
routers with an Lucent 5ESS Custom switch.

Point-to-Point Configuration

Table C-8 lists the router configuration requirements when using an Lucent 5ESS Custom
switch in a point-to-point configuration.
Table C-8
Parameter
Router software
Switch type
SPIDs
Directory number
1 This parameter is not set with a software command.
2 This parameter is not set when SPIDs are not used because it might cause unpredictable results.
NI1 Configuration
Configuration
U.S. version
NI1
At least one required
At least one required
Lucent 5ESS Custom Point-to-Point Configuration
Configuration
U.S. version
5ESS
None required
Optional
Software Command
1
–
set switch
2
set spid
set directory number
Software Command
1
–
set switch
2
–
set directory number
Provisioning the ISDN BRI Line C-11