Operator Programming Errors; Operator Programming Errors; Ope Codes, Causes, And Possible Solutions - YASKAWA V1000 Quick Start Manual

5.4

Operator Programming Errors

An Operator Programming Error (oPE) occurs when an inappropriate parameter is set or an
individual parameter setting is inappropriate.
u

oPE Codes, Causes, and Possible Solutions

LED Operator Display
YASKAWA ELECTRIC TOEP C710606 47A YASKAWA AC Drive – V1000 Quick Start Guide
Table 5.4 oPE Codes, Causes, and Possible Solutions
oPE01
oPE02
oPE03
oPE04
oPE05
oPE07
oPE08
oPE09
oPE10
oPE11
oPE13

5.4 Operator Programming Errors

Error Name
Drive Capacity Setting Fault
Drive capacity and the value set to o2-04 do not match.
Parameter Range Setting Error
Use U1-18 to find parameters set outside the range.
Multi-Function Input Selection Error
A contradictory setting is assigned to multi-function
contact inputs H1-01 to H1-07.
Initialization required.
Run Command/Frequency Reference Source Selection
Error
Multi-Function Analog Input Selection Error
A contradictory setting is assigned to multi-function
analog inputs H3-02 through to H3-10 and PID functions
conflict.
Parameter Selection Error
A function has been set that cannot be used in the motor
control method selected.
PID Control Selection Fault
PID control function selection is incorrect. Requires that
PID control is enabled (b5-01 = 1 to 4).
V/f Data Setting Error
The following setting errors have occurred where: E1-04
is greater than or equal to E1-06 is greater than or equal to
E1-07 is greater than or equal to E1-09.
Or the following setting errors have occurred: E3-04 is
greater than or equal to E3-06 is greater than or equal to
E3-07 is greater than or equal to E3-09.
Carrier Frequency Setting Error
Correct the setting for the carrier frequency.
Pulse Monitor Selection Error
Incorrect setting of monitor selection for Pulse Train
(H6-06).
5
149