Using The Digital Operator; Lcd Display - YASKAWA D1000 Series Quick Start Manual

5 Using the Digital Operator

5 Using the Digital Operator

LCD Display

Figure 16
No. Name
1 Operation Mode Menus
2 Mode Display Area
3 Ready
4 Data Display
DC Bus Voltage
5 Reference
Assignment
<1>
LO/RE
6
Display
<2>
Function Key 1
7
(F2)
Function Key 2
8
(F1)
<1> Displayed when in DC Bus Voltage Reference Mode.
<2> Displayed when in DC Bus Voltage Reference Mode and Monitor Mode.
28
1
- MODE -
Volt Ref (OPR)
U1-51= 330V
U1-52= 330V
U1-53= 0.00A
7
Figure 17 LCD Display
Table 15 Display and Contents
Display
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
SETUP Displayed when in Setup Mode.
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
Rdy Indicates the drive is ready to run.
– Displays specific data and operation data.
OPR Displayed when the DC Bus Voltage Reference is assigned to the LCD Operator Option.
AI Displayed when the DC Bus Voltage Reference is assigned to the drives Analog Input.
Displayed when the DC Bus Voltage Reference is assigned to the drives MEMOBUS/Modbus
COM
Communication Inputs.
OP Displayed when the DC Bus Voltage Reference is assigned to a drive Option Unit.
RSEQ Displayed when the reference is supplied from a remote source.
LSEQ Displayed when the reference is supplied from the operator keypad.
RREF Displayed when the frequency reference is supplied from a remote source.
LREF Displayed when the frequency reference is supplied from the operator keypad.
HELP
Pressing
F2
←
Pressing
F2
HOME
Pressing
F2
ESC
Pressing
F2
DATA
Pressing
F1
→
Pressing
F1
RESET
Pressing
F1
YASKAWA ELECTRIC TOEP C710656 06A YASKAWA Power Regenerative Converter - D1000 Quick Start Guide
2 3
DRV Rdy
RSEQ
LREF
8
Content
displays the Help menu.
scrolls the cursor to the left.
returns to the top menu (DC Bus Voltage Reference).
returns to the previous display.
scrolls to the next display.
scrolls the cursor to the right.
resets the existing drive fault or error.
YEU
4
5
6