YASKAWA V1000 Quick Start Manual page 170

B.1 Parameter Table
No.
Output Current 1 during Speed
b3-06
Search
Speed Search Detection
b3-10
Compensation Gain
Bi-Directional Speed Search
b3-14
Selection
b3-17 Speed Search Restart Current Level Refer to V1000 Technical Manual for details.
Speed Search Restart Detection
b3-18
Time
b3-19 Number of Speed Search Restarts
b3-24 Speed Search Method Selection
b3-25 Speed Search Retry Interval Time
Speed Search Induced Voltage Level Refer to V1000 Technical Manual for details.
b3-29
b4-01 Timer Function On-Delay Time
b4-02 Timer Function Off-Delay Time
b5-01 PID Function Setting
b5-02 Proportional Gain Setting (P)
b5-03 Integral Time Setting (I)
b5-04 Integral Limit Setting
b5-05 Derivative Time (D)
b5-06 PID Output Limit
b5-07 PID Offset Adjustment
b5-08 PID Primary Delay Time Constant
b5-09 PID Output Level Selection
b5-10 PID Output Gain Setting
b5-11 PID Output Reverse Selection
170
Name
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Note: Available in drive software versions PRG: 1020 and later.
b4: Timer Function
Use b4 parameters to configure timer function operation.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
b5: PID Control
Use b5 parameters to configure the PID control drive function.
0: Disabled
1: Enable (Deviation is D-controlled)
2: Enable (Feedback is D-controlled)
3: Enable (Deviation is D-controlled, PID output added to Freq. Ref.)
4: Enable (Feedback is D-controlled, PID output added to Freq. Ref.)
Sets the proportional gain of the PID controller. A setting of 0.00
disables P control.
Sets the integral time for the PID controller. A setting of 0.0 s disables
integral control.
Sets the maximum output possible from the integrator.
Sets D control derivative time. A setting of 0.00 s disables derivative
control.
Refer to V1000 Technical Manual for details.
Applies an offset to the PID controller output.
Sets the amount of time for the filter on the output of the PID
controller.
Refer to V1000 Technical Manual for details.
Sets the gain applied to the PID output.
Refer to V1000 Technical Manual for details.
YASKAWA ELECTRIC TOEP C710606 47A YASKAWA AC Drive – V1000 Quick Start Guide
Description